(For Phylon or EVA)
Release Agent BIO-900G is a water based mould release agent for Phylon or EVA. It will provide multiple releases for EVA compound and other EVA compounds equal to EVA rubber.
Benefits
[col_12]
[checklist]
- Multiple Releases
- Reduce Build-up
- Environmentally Friendly
- Waterbased Formulas
[/checklist]
[/col_12]
[col_12_last]
[checklist]
- Lower Scrap
- Better Cosmetics
- Increase Productivity
- Superior Release-Ease
[/checklist]
[/col_12_last]
[spacer]
Mould Surface Preparation
Clean mould with bead blast media, solvent and/or high pH detergent ( or other means )
to remove all traces of prior release agent and dirt build-up. Although BIO-900G may
work well on a dirty tool, starting with a clean tool will provide the best result.
Application of Release Agent BIO-900G
Dilution:
Bio-900 G could be diluted on a scale 1 : 70 –90 to water or by user reference.
The equipments should be above 180 oF or 82 oC to get the best results.
On spraying purpose, use light spray atomization, apply 3 light coats from different direction, allow the film to dry between coats.
To heat-up (up to 500 oF or 260 oC)
Use similar spraying technique to base coat. At temperatures above 250 oF or 121 oC the film will cure almost instantly. For touching-up, apply only 1 uniform light coating to prevent failure occurs and ensure best performance.
Packaging: BIO-900G product is available in 20 liter or 25 liter containers.
Handling and Storage:
The waterbased BIO-900G product is stable and require no mixing. Container should be keep closed and below 120 degrees Fahrenheit or 49 degrees Celcius. Keep out of freezing.
Safety Precaution: Read Material Safety Data Sheets.
